Analysis of Genetic makeup by simply Southern Blotting

The rapidly growing demand for lithium has resulted in a sharp increase in its price. This is due to the ubiquitous use of lithium-ion batteries (LIBs) in large-scale energy and transportation sectors as well as portable devices. Recycling of the LIBs for being the supply of critical metals hence becomes environmentally and economically viable. The presently used approaches for the recovery of spent LIBs like pyrometallurgical process can effectively recover nickel, cobalt, and copper, while lithium is usually lost in slag. Bioleaching process as an alternative method of extraction and recovery of valuable metals from the primary and secondary resources has been attracting a large pool of attraction. This method can provide higher recovery yield even for low concentration of metals which makes it viable among conventional methods. The bioleaching process can work with lower operating cost and consumed water and energy along with a simple condition, which produces less hazardous by-products ultimately. Here, we comprehensively review the biological and chemical mechanisms of the bioleaching process with a conclusive discussion to help how to extend the use of bioleaching for lithium extraction and recovery from the spent LIBs with a focus on recovery yields improvement. We elaborate on the three main types of the reported bioleaching with considering effective parameters including temperature, initial pH, pulp density, aeration, and medium and cell nutrients to sustain microorganism activity. Finally, practical challenges and future opportunities of lithium are discussed to inspire future research trends and pilot studies to realize the full potential of lithium recovery using sustainable bioleaching processes to extend a clean energy future.As the marine industry develops, the importance of seawater treatment process is increasing. To treat seawater, oxidation processes have primarily been used, such as ballast water treatment systems, aquaculture farm operations, aquarium management, and seawater desalination. However, dissolved organic matter in seawater, whose characteristics vary spatially and seasonally, affects the efficiency of oxidation processes. Therefore, in this study, seawater samples were acquired from various locations in the Republic of Korea to understand the spatio-temporal patterns of marine dissolved organic matter. It was reported that the characterization of marine dissolved organic matter using liquid chromatography-organic carbon detector and excitation-emission matrix-parallel factor modeling. Furthermore, the effects of marine dissolved organic matter were evaluated on ozonation, an oxidation process. The results demonstrate that marine dissolved organic matter varies in its aquagenic, pedogenic, and intermediate characteristics based on region and season. These variations affect ozonation by influencing the consumption of oxidants (e.g., bromine). As a result, it was concluded that characterizing marine dissolved organic matter can help improve the effectiveness of oxidation processes, particularly ozonation.A zinc-blende/wurtzite (ZB/WZ) copper indium sulfide (CuInS2/CIS) polymorph with high visible-light absorption ability and high charge separation rate was developed by using a facile polyol method. Results showed that when thioacetamide served as a sulfur precursor, the crystalline phase of CIS was zinc-blende. Meanwhile, when thiourea served as a sulfur precursor, the crystalline phase of CIS was wurtzite, which exhibited good photocatalytic acid red 1 (AR1) dye decolorization efficiency. When the precursor/ethylene glycol ratio was 1/50-7/50, the AR1 decolorization efficiency followed the order T-5-CIS > T-7-CIS > T-3-CIS > T-1-CIS, and the TOC removal efficiency of T-5-CIS was 45.7%. The PL and EIS analyses indicated that T-5-CIS showed the highest charge separation rate. Mott-Schottky analysis demonstrated that the remarkably enhanced photocatalytic decolorization rate was ascribed to the stronger reduction potential of CIS with the mixed ZB/WZ phases and the redox potential difference between the ZB and WZ phases, leading to a good oxidation ability and charge separation. The results indicated that O2- was the main reactive specie in this study, and this study provided a potential photocatalyst in the treatment of dye wastewater.Coagulation is a common method used to remove suspended particulate matter (SPM) from the water supply. SPM has preferable adsorption ability for antibiotics in water; therefore, SPM adsorption and coagulation may be a possible way to remove tetracycline (TC) from water. This study carried out coagulation experiments combining SPM collected from a natural lake at a location with three common coagulants-polyaluminum sulfate, polyaluminum chloride, and polyferric sulfate-under different pH values, exploring the adsorption of TC by SPM, coagulation of SPM with TC, and the primary influencing factors of this process. The maximum removal rate of TC can reach 97.87% with an SPM concentration of 1000 mg/L. Multi-factor analysis of variance showed the importance of various TC removal factors, which were ranked as follows SPM concentration ≫ initial TC concentration > type of coagulant > pH values. The higher the SPM concentration, the better the TC removal (p less then 0.001). Fourier infrared spectroscopy results demonstrated the strong adsorption effect of SPM on TC after being combined with a coagulant, and scanning electron microscopy also indicated that SPM becomes effective nuclei in the coagulation process, which is a possible reason for better TC removal. However, the effluent turbidities under 1000 mg/L SPM concentrations were high without coagulant aid. With the addition of coagulant aid anion polyacrylamide, the TC removal remained unchanged, effluent turbidity significantly reduced, and the TC desorption became low. These results indicate that applying SPM from natural lakes in the coagulation process could potentially remove TC in water.In this work, NiO level was varied from 5 to 40% whereas CexZr1-xO2 (x = 0.5, 0.7 and 0.9) (CZO) and La0.3Sr0.7Co0.7Fe0.3O3 (LSCF) were chosen as two different kinds of support. Regardless the type of support, the surface NiO (at 40%) was completely reduced at 600 °C, giving the amount of activated Ni at 8950 μmol/gcat. Tacrolimus solubility dmso The reducibility of the updoped LSCF was found to be much better than that of the undoped CZO, evidenced by the H2-TPR of the both materials at 600 °C where the oxygen storage capacity (OSC) of LSCF and CZO was determined at 4273 and 307 μmol/gcat, respectively. In contrast, the OSC of 40%Ni-CZO (where x = 0.7, 0.9) was found to be higher than that of the LSCF, implying that the addition of Ni more enhanced both electronic defect and oxygen mobility in CZO than in LSCF, according to the H2-TPR results. Coke resistant of CZO is presumable more satisfying than that of LSCF, thus, the longer lifespan of the CZO catalyst system is expected. The catalytic performance of 40%Ni-CZO (x = 0.9) was however comparable with 40%Ni-LSCF as they accommodate the same number of active sites.