Building Psychological Abilities and the Healing Alliance in Customers with Alexithymia Involvement Tips

This work focused on the experimental validation of software sensors with a view to improving on-line anaerobic digester monitoring. Based on cheaply available measurements such as conductivity, temperature, pH, redox potential, total suspended solids concentration and digester inflows and outflows, an intelligent estimator was built to reproduce the evolutions of key components such as volatile fatty acid, carbonate and alkalinity concentrations, as well as biogas composition (methane and carbon dioxide). The proposed solution considers a principal component pre-processing of the data selected as inputs of a radial basis function neural network (RBF-ANN) structure, using a particular sequential learning algorithm. Process dynamics were also taken into account, introducing a moving horizon version of this network (MH-RBF-ANN). Experimental results demonstrated the capacity of the MH-RBF-ANN to correctly predict the key-component evolutions and to improve the estimation accuracy, compared to the classical RBF-ANN.Absorption spectra within the infrared (IR) range of frequencies for nitrosamines in water are calculated using density function theory (DFT). Calculated in this study, are the IR spectra of C2H6N2O, C4H10N2O, C6H14N2O, C4H8N2O, C3H8N2O, and C8H18N2O. DFT calculated absorption spectra corresponding to vibration excited states of these molecules in continuous water background can be correlated with additional information obtained from laboratory measurements. The DFT software Gaussian was used for the calculations of excited states presented here. Bemcentinib This case study provides proof of concept, viz., that such DFT calculated spectra can be used for their practical detection in environmental samples. Thus, DFT calculated spectra may be used to construct templates, for spectral-feature comparison, and thus detection of spectral-signature features associated with target materials.In this study, iron ore slag as the photocatalyst was introduced into a constructed wetland simulation system. A comparative experiment of the constructed wetland method and photocatalysis-constructed wetland combination method that treats the high-salt chromium-containing wastewater was carried out. The best hydraulic retention time (HRT) of the photocatalysis-constructed wetland combination system was studied. The effects of these two methods on biochemical oxygen demand (BOD5), chemical oxygen demand (COD) removal and Cr(VI) reduction rate of the high-salt chromium-containing wastewater were analysed after 14 periods. The results showed that under the optimal HRT of 4 hours, the COD and BOD5 of the wastewater reduced by 47% and 31%, and the reduction rate of Cr(VI) was 83% separately in the constructed wetland system. The COD and BOD5 of the wastewater reduced by 83% and 42%, and the reduction rate of Cr(VI) was 96% separately in the photocatalysis-constructed wetland combination method system. At the same time, the changes in plant parameters under these two systems were studied, and the results showed that the addition of photocatalyst and hydrogen peroxide to constructed wetlands did not affect the normal indicators of plant growth. The results showed that the photocatalysis-constructed wetland combination method not only reduced the treatment time greatly, but also improved the quality of the treated wastewater significantly.In this study, phosphate-rich supernatant at the end of anaerobic phase was extracted by a certain side-stream ratio for chemical precipitation to investigate the optimal conditions for phosphorus recovery. The effect of side-stream reaction on the performance of the mainstream enhanced biological phosphorus removal (EBPR) system was also explored. The experiment was carried out in a sequencing batch reactor (SBR) operated in an alternating anaerobic/aerobic mode with dissolved oxygen controlled at 1.0 mg · L-1. The results showed that the optimum magnesium source,temperature, stirring speed and reaction equilibrium time for side-stream phosphorus recovery were MgCl2 · 6H2O, 25 °C, 150 rpm and 20 min, respectively. It was also observed that the average phosphorus removal efficiency of the mainstream system maintained as high as 90.7% during the side-stream extraction period despite insufficient time for phosphate uptake under limited dissolved oxygen condition and phosphate deprivation of polyphosphate-accumulating organisms (PAOs). Besides, the sludge settling performance of the mainstream EBPR system decreased with no sludge loss. Afterwards, phosphorus removal and sludge settling performance were restored with dismissing side-stream phosphorus recovery. This study suggested that side-stream extraction of anaerobic supernatant from a mainstream EBPR subjected to low dissolved oxygen conditions for chemical phosphorus recovery was feasible and environmentally friendly.A novel graphene wool (GW) material was used as adsorbent for the removal of phenanthrene (PHEN) and pyrene (PYR) from aqueous solution. Adsorption kinetics, adsorption isotherms, thermodynamics of adsorption and effect of pH, ionic strength, and temperature on the adsorption of PHEN and PYR onto GW were comprehensively investigated. Isothermal and kinetic experimental data were fitted to Langmuir, Freundlich, Temkin, Sips and Dubinin-Radushkevich models, as well as pseudo-first-order and pseudo-second-order kinetic models. The adsorption kinetic data best fit the pseudo-second-order kinetic model for PHEN and PYR sorption with R2 value >0.999, whilst the Sips model best fit isotherm data. Kinetic data revealed that 24 hr of contact between adsorbent and polycyclic aromatic hydrocarbons (PAHs) was sufficient for maximum adsorption, where the Langmuir maximum adsorption capacity of GW for PHEN and PYR was 5 and 20 mg g-1 and the optimum removal efficiency was 99.9% and 99.1%, respectively. Thermodynamic experiments revealed that adsorption processes were endothermic and spontaneous. Desorption experiments indicated that irreversible sorption occurred with a hysteresis index greater that zero for both PAHs. The high adsorption capacity and potential reusability of GW makes it a very attractive material for removal of hydrophobic organic micro-pollutants from water.