Chats Adjust Folks and individuals Change the Globe

A novel, to the best of our knowledge, interrogation scheme based on an optoelectronic oscillator (OEO) with high sensitivity and high speed response for a fiber optical current sensor utilizing a reflective interferometer is proposed and experimentally demonstrated. Due to the Faraday effect, a magneto-optic phase shift induced by current variation is generated between two orthogonal light waves. The polarization-dependent properties of the Mach-Zehnder modulator are used to convert the magneto-optic phase shift into the phase difference between the optical carrier and sideband, which is then mapped to the oscillating frequency shift by closing an OEO loop. A high current sensitivity of 152.5 kHz/A with a range of 0-2.5 A is obtained in the experiment.Based on the concepts of conservative and non-conservative optical forces (COF and NCOF), we analyze the physical mechanism of longitudinal chirality sorting along the direction of light propagation in some simple optical fields. It is demonstrated, both numerically and analytically for particle of arbitrary size, that the sorting relies solely on the NCOF, which switches its direction when particle chirality is reversed. For particles larger than half of the optical wavelength λ, the NCOF far surpasses its counterpart COF, enabling the longitudinal chirality sorting. When the particle is much smaller than λ, however, the COF outweighs the NCOF, destroying the sorting mechanism. A scenario is thus proposed that totally eliminates the COF while leaving the sorting NCOF unchanged, extending the applicability of longitudinal chirality sorting to small particles.This Letter presents the efficient laser operation of a TmCaF2 crystal in-band pumped at 1610 nm by an Er-Yb-codoped fiber laser system. A laser slope efficiency of 55% (versus incident pump power) was achieved in a continuous-wave regime, with a maximum output power of 1.25 W at ∼1.88µm in a nearly diffraction-limited beam (M2=1.14). We also demonstrated a continuous tuning range of 180 nm, which extends to short wavelengths down to 1773 nm.We have experimentally investigated supercontinuum (SC) generation and the evolution of optical damage in sapphire and YAG crystals with 180 fs, 1035 nm pulses from an amplified YbKGW laser with variable repetition rates, both in tight and loose focusing conditions. In this Letter, we demonstrate that the extinction of the SC spectrum always correlates with an occurrence of conical third harmonic generation, which readily serves as an indication of the onset of in-bulk optical damage. Damage-related structural changes of the nonlinear material are also justified by an increased intensity and large red shift of crystal luminescence spectrum corresponding to the F center emission. The SC spectrum in sapphire starts shrinking on the time scale between seconds and minutes by varying the focusing condition from tight to loose at the laser repetition rate of 200 kHz, whereas the YAG crystal produces stable performance for several hours at least.We generated time-multiplexed degenerate optical parametric oscillator (DOPO) pulses using a nonlinear fiber Sagnac loop as a phase-sensitive amplifier (PSA), where the pump and amplified light in pump-signal-idler degenerate four-wave mixing can be spatially separated. By placing the PSA in a fiber cavity, we successfully generated more than 5000 time-multiplexed DOPO pulses. We confirmed the bifurcation of pulse phases to 0 or π relative to the pump phase, which makes them useful for representing Ising spins in an Ising model solver based on coherent optical oscillator networks. We also confirmed inherent randomness of the DOPO phases using the National Institute of Standards and Technology random number test.We demonstrate ultrabroadband supercontinuum generation from ultraviolet to mid-infrared wavelengths in single-crystalline aluminum nitride waveguides. Tunable dispersive waves are observed at the mid-infrared regime by precisely controlling the waveguide widths. In addition, ultraviolet light is generated through cascaded second-harmonic generation in the modal phase-matched waveguides. Numerical simulation indicates a high degree of coherence of the generated spectrum at around the telecom pump and two dispersive waves. Our results establish a reliable path for multiple octave supercontinuum comb generation in single-crystalline aluminum nitride to enable applications including precision frequency metrology and spectroscopy.We present an erratum to our Letter [Opt. Lett.45, 3601 (2020)OPLEDP0146-959210.1364/OL.395341]. Labeling errors in two figures and an incorrect sentence are revised. The corrections have no influence on the conclusions of the original Letter.Some comments about the recently published Optics Letters paper by Su et al. [Opt. Lett.45, 379 (2020)OPLEDP0146-959210.1364/OL.377453] are provided.Although sub-bandgap light absorption signals in organic donor/acceptor (D/A) photovoltaic systems have been studied extensively, the underlying origins, as well as the impacting factors, are still elusive. By theoretically constructing an organic D/A interface under a femtosecond electric pulse pumping, we obtain an insightful understanding of this issue. First, a careful comparison between the absorption spectra of the D/A interface and the individual donor (acceptor) demonstrates the existence of two weak absorption signals below the donor (acceptor) optical gap. Furthermore, we clarify that the lower-energy signal originates from "cold" charge transfer (CT) absorption, while the higher-energy signal is from "hot" CT absorption. Finally, effects of several key factors, such as the interface structure and the photoexciting condition, on CT absorptions are discussed. These findings should be of vital importance both to understand the sub-bandgap excited states and to recognize their roles in organic photovoltaic devices.This Letter presents a pulsed, Fourier transform limited 1030 nm laser with a variable pulse duration between 47 and 733 ps resulting in a spectral bandwidth of roughly 1 to 10 GHz. The laser system is based on ytterbium-doped fiber amplifiers and acousto-optic and electro-optic modulation technology. The repetition rate can be set arbitrarily between 1 and 10 MHz. After three sequential amplifier stages, the average output power reaches a maximum of over 60 W. The particular fiber amplifier geometry allows to prevent the emergence of unwanted nonlinear effects. Momelotinib nmr Due to its unique features, the laser system lends itself to a variety of applications wherever flexibility in terms of pulse duration and corresponding Fourier limited bandwidth are required, such as laser cooling at storage rings, lidar applications, or coherent molecular spectroscopy.