Remote extratesticular hematoma from intraoperative positioning throughout lumbar spine surgical treatment

9 between the actual and predicted values with an average absolute percentage error (AAPE) below 5.7% for the training and testing data sets. ANFIS models will help to track in real-time the rheological properties for invert emulsion mud that allows better control for the drilling operation problems.This paper is dedicated to some aspects of maritime on-board safety improvement. The contribution of this article is a proposal to extend wireless communication on the ship, supported by examples of solutions that have not previously been used on board. Analyzed aspects concern the measurement and control signal transmission in hostile marine environment. A problem to solve is formulated, how to reduce a negative impact of this environment on effectiveness and reliability of maritime on board communication. The proposed ways for solving a problem under consideration cover recommendations concerning some aspects of ship construction and implementation of wireless sensor network. The main topic faced by the paper is concentrated on case study-based ZigBee as well as WiFi networks implementation in the area of the acquisition of data from sensors and measuring transducers connected to the terminal network. The exemplary implementation of ZigBee network, elaborated in Gdynia Maritime University is related, firstly, to the configuration of a simple wireless measurement and control channel, and secondly, to wireless communication channel supported by autonomously working microprocessor measurement and control system. WiFi networks were also tested in the same area of application. Finally, some concluding remarks are formulated.Very high IgM levels represent the hallmark of hyper IgM (HIGM) syndromes, a group of primary immunodeficiencies (PIDs) characterized by susceptibility to infections and malignancies. Other PIDs not fulfilling the diagnostic criteria for HIGM syndromes can also be characterized by high IgM levels and susceptibility to malignancies. The aim of this study is to characterize clinical phenotype, immune impairment, and pathogenic mechanism in six patients with very high IgM levels in whom classical HIGM syndromes were ruled out. The immunological analysis included extended B-cell immunophenotyping, evaluation of class switch recombination and somatic hypermutation, and next generation sequencing (NGS). Recurrent or severe infections and chronic lung changes at the diagnosis were reported in five out of six and two out of six patients, respectively. Five out of six patients showed signs of lymphoproliferation and four patients developed malignancies. Four patients showed impaired B-cell homeostasis. Class switch recombination was functional in vivo in all patients. NGS revealed, in one case, a pathogenic mutation in PIK3R1. In a second case, the ITPKB gene, implicated in B- and T-cell development, survival, and activity was identified as a potential candidate gene. Independent of the genetic basis, very high IgM levels represent a risk factor for the development of recurrent infections leading to chronic lung changes, lymphoproliferation, and high risk of malignancies.The corrosion behavior of duplex Ni-P coatings deposited on AZ91 magnesium alloy was studied. The electroless deposition process of duplex Ni-P coating consisted in the preparation of low-phosphorus Ni-P coating (5.7 wt.% of P), which served as a bond coating and high-phosphorus Ni-P coating (11.5 wt.% of P) deposited on it. The duplex Ni-P coatings with the thickness of 25, 50, 75 and 100 µm were deposited on AZ91 magnesium alloy. The electrochemical corrosion behavior of coated AZ91 magnesium alloy was investigated by electrochemical impedance spectroscopy and potentiodynamic polarization method in 0.1 M NaCl. Obtained results showed a significant improvement in the corrosion resistance of coated specimens when compared to uncoated AZ91 magnesium alloy. From the results of the immersion tests in 3.5 wt.% NaCl, 10% solution of HCl and NaOH and 5% neutral salt spray, a noticeable increase in the corrosion resistance with the increasing thickness of the Ni-P coating was observed.It is generally known that significant improvements in the properties of nanocomposites can be achieved with graphene types currently commercially available. However, so far this is only possible on a laboratory scale. Thus, the aim of this study was to transfer results from laboratory scale experiments to industrial processes. Therefore, nanocomposites based on polyamide (PA) and graphene nanoplatelets (GnP) were prepared in order to produce membranes with improved gas barrier properties, which are characterized by reduced permeation rates of helium. First, nanocomposites were prepared with different amounts of commercial availably graphene nanoplatelets using a semi-industrial-scale compounder. Subsequently, films were produced by compression molding at different temperatures, as well as by flat film extrusion. The extruded films were annealed at different temperatures and durations. In order to investigate the effect of thermal treatment on barrier properties in correlation to thermal, structural, and morphological properties, the films were characterized by differential scanning calorimetry (DSC), wide angle X-ray scattering (WAXS), optical microscopy (OM), transmission electron microscopy (TEM), melt rheology measurements, and permeation measurements. In addition to structural characterization, mechanical properties were investigated. The results demonstrate that the permeation rate is strongly influenced by the processing conditions and the filler content. If the filler content is increased, the permeation rate is reduced. The annealing process can further enhance this effect.The increasing popularity of electronic cigarettes in past decades has aroused public health concern. Oprozomib price This study aims to review the literature on the prevalence of e-cigarette use among the general adult and young populations in Europe. We searched Medline and Google Scholar from September 2019, and included "prevalence of e-cigarettes", "electronic cigarettes" or "e-cigarettes", and "electronic nicotine delivery system" or "vaping". The prevalence of current e-cigarette use ranged from 0.2% to 27%, ever-use ranged from 5.5% to 56.6% and daily use ranged from 1% to 2.9%. Current smokers of conventional cigarettes showed the highest prevalence for the use of e-cigarettes, ranging from 20.4% to 83.1%, followed by ex-smokers, with ranges from 7% to 15%. The following socio-demographic factors were associated with a higher chance of using e-cigarettes male sex and younger age groups; results for economic status were inconclusive. In European countries, there is a higher prevalence of e-cigarette use among males, adolescents and young adults, smokers of conventional cigarettes, and former smokers.